Turntable Accessories

Notes: 12" acrylic stroboscopic disc for all speeds: 8 1/3, 16 2/3, 33 1/3, 45, 70, 72, 73, 75, 76, 78, 80, 81, 83, 85, 87, 90 RPM.

Notes: Crystal turntable mat is lighter and harder than aluminum and coated with a special technique. It helps produce a crystal clear sound with excellent separation.

Notes: This unique tonearm alignment gauge allows you to check the tonearm geometry of your record player and to install the pick-up ideally aligned to keep distortion to a minimum.

Instructions are included

Notes: Any vibrations in the record during playback will be picked by the cartridge and will be reproduced by the amplifier and speakers causing muddy sound, distortion and reduced detail. In order to avoid record vibrations you must make sure that the contact between the record and the platter is as perfecrt as possible.The tonar record clamp presses the record flat against the platter. Put the record on the turntable and then put the clamp on the spindle, press down & turn the knob to tighten. The weight of the clamp is minimal so it can be used on any record player with a fixed spindle.

Also many older manufactured records are warped to varying degrees, this causes big problems for the diamond stylus of the cartridge to track the grooves properly. The stylus pressure fluctuates as the stylus moves up and down while trying to track the warps. With bad results: muddy sound reproduction with distortions and if the turntables drive isn't really strong... audible flutter. In some cases the stylus may actually loose contact with the groove causing a hissing sound. Using the Tonarclampit will press the record onto the turntable platter, and the problematic surface will be flattened while you play the record causing a dramatic improvement of the reproduced sound on old records.

Take care that the platter bearing of your turntable is able to accept the additional weight of 760 g. If in any doubt please consult your record player instructions or your dealer before buying or using this weight.

760 grams Brass weight
Measurements: 78 mm x 25 mm

Base covered with felt to protect the record label